Lab 9.4.1.2

Packet Tracer – Skill Integration Challenge

Addressing Table

Router Branch- A

Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#hostname Branch-A
Branch-A(config)#banner motd #This is Branch A#
Branch-A(config)#line console 0
Branch-A(config-line)#login
% Login disabled on line 0, until 'password' is set
Branch-A(config-line)#password cisco
Branch-A(config-line)#login
Branch-A(config-line)#line vty 0 4
Branch-A(config-line)#password cisco
Branch-A(config-line)#login
Branch-A(config-line)#exit
Branch-A(config)#enable password cisco
Branch-A(config)#enable secret class
Branch-A(config)#service pass
Branch-A(config)#service password-encryption 
Branch-A(config)#int g0/0
Branch-A(config-if)#ip add 172.20.16.1 255.255.254.0
Branch-A(config-if)#no shut

Branch-A(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to up

Branch-A(config-if)#description #This is interface LAN A1#
Branch-A(config-if)#int g0/1
Branch-A(config-if)#ip add 172.20.18.1 255.255.255.0
Branch-A(config-if)#no shut

Branch-A(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to up

Branch-A(config-if)#description #This is interface LAN A2#
Branch-A(config-if)#int g0/2
Branch-A(config-if)#ip add 172.20.31.254 255.255.255.252
Branch-A(config-if)#no sh

Branch-A(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/2, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to up

Branch-A(config-if)#description #This is interface WAN#
Branch-A(config-if)#exit
Branch-A(config)#exit
Branch-A#
%SYS-5-CONFIG_I: Configured from console by console

Branch-A#copy run start
Destination filename [startup-config]? 
Building configuration...
[OK]
Branch-A#

Router Branch – B

Router>
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#hostname Branch-B
Branch-B(config)#banner motd #This is Branch-B#
Branch-B(config)#line console 0
Branch-B(config-line)#password cisco
Branch-B(config-line)#login
Branch-B(config-line)#line vty 0 4
Branch-B(config-line)#password cisco
Branch-B(config-line)#login 
Branch-B(config-line)#exit
Branch-B(config)#enable password cisco
Branch-B(config)#enable secret class
Branch-B(config)#service pass
Branch-B(config)#service password-encryption 
Branch-B(config)#int g0/0
Branch-B(config-if)#ipv6 address 2001:DB8:FADE:00FF::1/64
Branch-B(config-if)#ipv6 address FE80::B link-local
Branch-B(config-if)#no shut

Branch-B(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0, changed state to up

Branch-B(config-if)#int g0/1
Branch-B(config-if)#ipv6 address 2001:DB8:FADE:0100::1/64
Branch-B(config-if)#ipv6 address FE80::B link-local
Branch-B(config-if)#no shut

Branch-B(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to up

Branch-B(config-if)#int g0/2
Branch-B(config-if)#ipv6 address 2001:DB8:FFFF:FFFF::2/64
Branch-B(config-if)#ipv6 address FE80::B link-local
Branch-B(config-if)#no shut

Branch-B(config-if)#
%LINK-5-CHANGED: Interface GigabitEthernet0/2, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to up

Branch-B(config-if)#exit
Branch-B(config)#exit
Branch-B#
%SYS-5-CONFIG_I: Configured from console by console

Branch-B#copy run start
Destination filename [startup-config]? 
Building configuration...
[OK]
Branch-B#

PC-A1

PC-A2

PC-B1

PC-B2

Tests